This manual includes a description of the functions and capabilities and presents instructions as step-by-step procedures.
Motorola Remote Control 1072Ba1-H-C-A Manual Is TheReading the Official Installation Manual is the safest way to preserve the legal guarantee in setting up the product properly.It covers the servicing, maintenance and repair of the product.Exploded views allow to identify all the part numbers and associated parts with the product in case they need to be replaced.
Motorola Remote Control 1072Ba1-H-C-A Manual Includes AThe schematics are helpful to repair the product in case of dysfunction. To have POWER button toggle your satellite receiver and other devices (such as your TV) on and off at the same time, follow the instructions below. To check which model of remote control you currently have, please see the sticker on the back of the remote. The Shaw Direct IRC 600URC 600 Remote Controls by Universal Electronics are our latest generation universal remote controls. On the top of your remote, press and hold the TV button until the others (AUX, SAT) flash at least 3 to 4 times. Press POWER button. If the TV turns off, you have successfully programmed your remote with the TV. If not, repeat steps 2-3 using different codes given for your brand of the TV. Press and hold the TV button until the others (AUX, SAT) flash at least 3 to 4 times. Test the Volume andor Power to see if the TV responds to the remotes commands. If two UHF-enabled receivers are in close distance to each other, the remotes may control the incorrect receiver; however, you can set a custom remote address to prevent this. See My receiver changes channels itself for more information. Both your satellite receiver and Shaw Direct remote need to be changed to a new address in order to keep them tied together. First method: Press and hold SAT button until the others (TV, AUX) flash at least 3 to 4 times Press the 3 digit remote code: 000 After punching in the code, press the POWER button and see if the receiver turns off. If receiver turns off, your remote has been successfully programmed. Other codes are: Receiver Codes 000 001 002 003 004 005 006 007 Second method: Press and hold SAT button until the others (TV, AUX) flash at least 3 to 4 times. Press 9-9-1. Press CH button once per second until the receiver turns off. Make sure to not press the button again once the receiver is off. To enable it on your remote: Press and hold SAT button until the others (TV, AUX) flash at least three times. ![]() Press CH. SAT button should blink twice. Note: To remove the channel lock feature, repeat the above steps but use CH- button instead. When disabled, volume is controlled based on what mode is selected (TV or AUX). Note: The master volume feature is on by default, as soon as your TV code is programmed as outlined above. Before proceeding to the next steps, ensure your TV code is programmed. To enable master volume: Press and hold SAT button until the others (TV and AUX) flash at least three times. Press the device key (TV or AUX button) you would like to lock volume to, which should then also blink twice. To disable master volume: Press and hold the device key (SAT, TV, or AUX button) you wish to unlock (until the mode buttons flash at least three times).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |